a.s.04.03.15/issue d filename: sd-69020-0770 arbor press fixture part no. 69020-0770 for molex product 7660,7664,7674 and 7675 description this fixture will terminate molex product 7660,7664,7674 and 7675. features 1. this fixture can only be used in a standard arbor press part no. 69020-0660. 2. cables guides and cable stop. 3. for use with notched cable and discrete wire. 4. colour bar in/out options included. specification size: 210mm x 160mm x 120mm weight: 3kg working services: none
a.s.04.03.15/issue d filename: sd-69020-0770 set-up 1) fix upper block onto arbor press spindle and tighten locking screw. 2) place lower termination fixture onto mounting platform of arbor press. 3) make a few samples following the next section (operation) and then check termination heights. if adjustment is required see adjustments section. operation 1) insert connector into lower termination block. 2) place pre-cut cable over connector. 3) pull handle of arbor press down fully to terminate connector. 4) return handle to start position. 5) release connector latch and slide harness backwards out of fixture.
a.s.04.03.15/issue d filename: sd-69020-0770 adjustments 1) if termination height is incorrect then follow the procedure below. 2) loosen the stud nuts in the centre of the arbor press. 3) loosen clamp bolt to column at the rear of the arbor press. 4) adjust upper part of arbor press up or down using the nuts on the central stud. 5) re-tighten nuts and clamp bolt. 6) recheck termination height. maintenance 1. keep fixture clean at all times. 2. clean fixture with brush. 3. oil moving parts weekly, when in use. 4. store in a clean dry environment. spare parts number description 69020-0415 insertion blade (lh/rh) 2-off 69020-0416 insertion blade (centre) 1-off refer to assembly drawing for other parts if required. quality check termination quality against the molex wire termination specification for relevant product being terminated e.g.: ps- 90650. a quality procedure should be in place to monitor output from this fixture. limitations this arbor press can only be used for product stated in the description section of this leaflet.
|